Ballyganner North : Court Tomb

Grid RefR 219 957
Longitude9° 9' 48.94" W
Latitude53° 0' 22.88" N
ITM east480366
ITM north584435
Nearest TownKilfenora (3.9 Km)
OS Sheet51
UTM zone29U
UTM x449041
UTM y5761192
Hide map  (N.B. Google Maps & GPS readings are slightly out of sync - position is approximate)
Show inline map (by Google Maps)

Visit Notes

Sunday, 30th March 2003

This tomb takes some finding. The trek across the Burren limestone pavement is an arduous one and as usual while walking across here I turned my ankle several times.

The tomb is now represented by a 4m long gallery which is aligned north-south; with the entrance via a very narrow court at the north end. This is very reminiscent of Shanballyedmond (County Tipperary). On the west side there are traces of a kerb just 2.5m from the gallery itself and there is a hint of double walling, perhaps representing a link with the wedge tomb builders in the area.

The shallow court is extremely difficult to make out as it is now very overgrown and full of rubble, but the entrance is unmistakable due to it being marked by two 1.1m tall entrance jambs. Beyond these are two more jambs which split the chamber more or less in half - a corbel stone rests against these now and looks at first like a septal slab.

The rear of the gallery is interesting. The backstone leans in slightly and is almost gable shaped. Just inside the gallery, right by the back stone is a peculiar pillar - seemingly another jamb.

10m to the NE is a very low standing stone, the purpose of which it is impossible to say.

Like this monument

Marked Sites

Random Gazetteer

A Selection of Other Court Tombs

About Coordinates Displayed

This is an explanation of (and a bit of a disclaimer for) the coordinates I provide.

Where a GPS figure is given this is the master for all other coordinates. According to my Garmin these are quite accurate.

Where there is no GPS figure the 6 figure grid reference is master for the others. This may not be very accurate as it could have come from the OS maps and could have been read by eye. Consequently, all other cordinates are going to have inaccuracies.

The calculation of Longitude and Latitude uses an algorithm that is not 100% accurate. The long/lat figures are used as a basis for calculating the UTM & ITM coordinates. Consequently, UTM & ITM coordinates are slightly out.

UTM is a global coordinate system - Universal Transverse Mercator - that is at the core of the GPS system.

ITM is the new coordinate system - Irish Transverse Mercator - that is more accurate and more GPS friendly than the Irish Grid Reference system. This will be used on the next generation of Irish OS maps.

Valid CSS Valid HTML
Page loaded from cache: (Generation time: February 24 2020 10:01:37.)
Top of page | Feedback | About this site
© Copyright Tom FourWinds 2001-2020