Keadeen : Cairn

CountyWicklow
Grid RefS 944 896
GPSS 94380 89626 (7m)
Longitude6° 35' 44.5" W
Latitude52° 56' 57" N
ITM east480366
ITM north584435
Nearest TownKiltegan (5 Km)
OS Sheet62
UTM zone29U
UTM x449041
UTM y5761192
Hide map  (N.B. Google Maps & GPS readings are slightly out of sync - position is approximate)
Show inline map (by Google Maps)

Visit Notes

Sunday, 5th December 2004

Trudging up the boggy hill to reach the standing stone at Keadeen (County Wicklow) I came across this unusual pair of conjoined cairns . They are of different sizes with the larger one being 5m across and the smaller one just 3m. There are several orthostats around the edge of each one, which presumably once formed a kerb .

A line drawn though the centre of each cairn goes straight through the standing stone 100m away up the hill.

Standing stones, also called menhirs or monoliths, are the most simple of megalithic monuments. They are exactly what they say, a stone that stands with one end set into the ground. Being simple in form does not make them simple to understand, for they have served several purposes over time. Some were placed to mark burials, others were probably erected to mark boundaries or travel routes, the purpose of others is uncertain, but it may well have been ritual.

Standing stones can vary enormously in size from a under 1m tall to over 4m. Some have been purposely shaped (see Stone Of Destiny (County Meath)) and some must have been chosen purely for their shape (see Ballyvatheen (County Kilkenny)). Most standing stones are dated to be from the Bronze Age, but some are clearly older, especially those associated with passage tombs such as at Knowth (County Meath) and Loughcrew - Corstown (County Meath).

Others have been re-used in later times (see Kilnasaggart (County Armagh) and Breastagh (County Mayo)), perhaps to try and capture some of the powers of the old gods or to legitamise a claim to land.

A kerb is a ring of stones placed around the perimeter of a burial mound or cairn. It basically serves the purpose of a retaining wall to keep the cairn or earth in place. Kerbs are usually associated with passage tombs, but do occur on court tombs and wedge tombs too.

Sometimes on passage tombs the stones can bear decoration, such as at Newgrange (County Meath).

A barrow is essentially a mound of earth over one or more burials. They are more usually to be dated to the Bronze Age. There are many forms of barrow including ring, bowl, long and bell barrows.

Ring barrows are formed by digging a circular trench or fosse around a central burial, with no mound.

Bowl barrows are formed by heaping up soil over the burial(s) from a surrounding fosse, these often have an external bank too (see Ballyremon Commons (County Wicklow)).

Bell barows are simply round mounds with no fosse or external bank.

Long barrows are rare in Ireland and are more common in southwest England. Their shape is basically ovoid rather than round (see Ballynoe (County Down))

A kerb is a ring of stones placed around the perimeter of a burial mound or cairn. It basically serves the purpose of a retaining wall to keep the cairn or earth in place. Kerbs are usually associated with passage tombs, but do occur on court tombs and wedge tombs too.

Sometimes on passage tombs the stones can bear decoration, such as at Newgrange (County Meath).

Click Thumbnail to View Full Size Image

___

Like this monument

Marked Sites

Random Gazetteer

A Selection of Other Cairns

About Coordinates Displayed

This is an explanation of (and a bit of a disclaimer for) the coordinates I provide.

Where a GPS figure is given this is the master for all other coordinates. According to my Garmin these are quite accurate.

Where there is no GPS figure the 6 figure grid reference is master for the others. This may not be very accurate as it could have come from the OS maps and could have been read by eye. Consequently, all other cordinates are going to have inaccuracies.

The calculation of Longitude and Latitude uses an algorithm that is not 100% accurate. The long/lat figures are used as a basis for calculating the UTM & ITM coordinates. Consequently, UTM & ITM coordinates are slightly out.

UTM is a global coordinate system - Universal Transverse Mercator - that is at the core of the GPS system.

ITM is the new coordinate system - Irish Transverse Mercator - that is more accurate and more GPS friendly than the Irish Grid Reference system. This will be used on the next generation of Irish OS maps.

Valid CSS Valid HTML
Page loaded from cache: (Generation time: August 19 2018 00:25:36.)
Top of page | Feedback | About this site
© Copyright Tom FourWinds 2001-2018